#Put gopro app in pairing mode Bluetooth#

The camera will whitelist the client so subsequent connections do not require pairing. To pair with the camera, use the UI to put it into pairing mode, connect via BLE and then initiate pairing. If the camera is factory reset, all clients will need to pair again. The pairing procedure must be done once for each new client. In order to communicate with a GoPro camera via BLE, a client must first be paired with the camera.

If the camera is in sleep mode, connecting to it will cause the camera to wake and boot up. The camera will send BLE advertisements while it is ON and for the first 8 hours after the camera is put to sleep.Дuring this time, the camera is discoverable and can be connected to. The packet count starts at 0 for the first continuation packet.Дiscovery, Connection and Pairing Advertisements To accommodate this limitation, the packet header rules below are used.

#Put gopro app in pairing mode Bluetooth#

The Bluetooth Low Energy protocol limits messages to 20 Bytes per packet. Note: GP-XXXX is shorthand for GoPro's 128-bit UUIDs: b5f9xxxx-aa8d-11e3-9046-0002a5d5c51b Service UUID The camera organizes its Generic Attribute Profile (GATT) table by broad features: AP control, network management,Д«elow is a table of cameras that support GoPro's public BLE API: Waiting for a response notification from a corresponding characteristic. GeneralД¬ommunicating with a GoPro camera via Bluetooth Low Energy involves writing to Bluetooth characteristics and, typically, Messages are sent using either TLV or Protobuf format. This page describes the format, capabilities, and use of Bluetooth Low Energy (BLE) as it pertains to communicating with GoPro cameras. Bluetooth Low Energy (BLE) Specification v1.0